Escort Prism 20401 Specifiche Scaricare il pdf (Pagina 101)

7-4

Noninvasive Blood Pressure (NIBP) Messages

NIBP MESSAGE MEANING

ET = MM:SS Indicates elapsed time (ET) since last NIBP measurement.

AET = MM:SS Indicates elapsed time since last NIBP measurement while auto

timer is on.

AUTO Monitor is in NIBP AUTO mode.

CUFF = XXX Displays as the cuff inflates and deflates, giving the pressure in

mmHg.

LOW OSCIL Oscillation amplitudes are too low to obtain measurement.

ARTIFACT Excessive artifact precluded measurement within a 145-second

timeout.

MAX 2 LOW Cuff inflation was too low to take a reading. May indicate either

incorrect operating mode (ADULT, PED, NEO) or a need to

increase the initial inflation.

CHECK CUF 40-second timeout exceeded for inflation to at least 20 mmHg.

ETCO2 Messages

ETCO

MESSAGE MEANING

NO SENSOR The MediCO2 module has detected that NO FilterLine is

currently connected. This message will remain displayed until a

FilterLine is connected or another CO2 status message is

displayed.

WARM UP This message is displayed for approximately 5-10 seconds after

the installation of the FilterLine, or after power-up with the

FilterLine already installed.

FILT OCCL The MediCO2 module has detected an airway blockage. If

blockage remains for more than 30 seconds, the MediCO2

module will go into standby mode and this message will remain

displayed until FilterLine is disconnected.

CO2 ERROR This message will be displayed if the CO/CO2 firmware has not

received valid data from the MediCO2 module for more than 30

seconds.

ICO2 This message will be displayed when the INSPIRED CO2 value

has exceeded the alarm limit set in the CO2 Setup page in deep

configuration or in the Alarm Limits page under the CO2

Parameter menu.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 169 170

Nessun commento

Escort Prism 20401 Specifiche Pagina 101